| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Out-of-bounds read in Windows Installer allows an authorized attacker to disclose information locally. |
| In the Linux kernel, the following vulnerability has been resolved:
dm ioctl: don't let data_start run past the buffer
struct dm_ioctl has seven bytes of trailing padding, so the smallest
buffer userspace is allowed to ask for, offsetof(struct dm_ioctl, data),
is seven bytes shorter than sizeof(struct dm_ioctl).
get_result_buffer() sets data_start to sizeof(struct dm_ioctl) without
looking at how big the buffer actually is. Ask for the minimum and
data_start ends up seven bytes past the end. Callers add it to
data_size, and ctl_ioctl() copies that much back to userspace:
BUG: KASAN: slab-out-of-bounds in _copy_to_user+0xad/0xd0
Read of size 312 at addr ffff8880169e4c00 by task repro-dm/140
ctl_ioctl+0x5e3/0xcb0
dm_ctl_ioctl+0x25/0x40
allocated 305-byte region [ffff8880169e4c00, ffff8880169e4d31)
A DM_LIST_DEVICES with data_size set to 305 is enough to hit it, and the
seven bytes that leak are whatever sat next to the allocation.
Clamp data_start to the buffer size.
Note that this is not a security bug because the out-of-bounds read can
only be triggered by root. |
| In the Linux kernel, the following vulnerability has been resolved:
bnxt_en: fix DMA mapping length for padded small packets
Stefan Fleischmann reported Intel IOMMU DMA Read faults on BCM57412
NetXtreme-E NICs when transmitting packets on VLAN/macvlan interfaces:
DMAR: [DMA Read NO_PASID] Request device [18:00.0] fault addr 0xfc499000
[fault reason 0x06] PTE Read access is not set
bnxt_en 0000:18:00.0 eno1np0: Abandoning msg {0xb4 0x41a} len: 0 due to firmware status: 0x2000001
...
NETDEV WATCHDOG: eno1np0 (bnxt_en): transmit queue 0 timed out
The fault address (0xfc499000) is on an exact 4KB page boundary,
pointing to a DMA read buffer overrun.
In bnxt_start_xmit(), packets smaller than BNXT_MIN_PKT_SIZE (52 bytes),
such as 42-byte untagged ARP frames, are padded:
if (length < BNXT_MIN_PKT_SIZE) {
pad = BNXT_MIN_PKT_SIZE - length;
if (skb_pad(skb, pad))
goto tx_kick_pending;
length = BNXT_MIN_PKT_SIZE;
}
mapping = dma_map_single(&pdev->dev, skb->data, len, DMA_TO_DEVICE);
...
dma_unmap_len_set(tx_buf, len, len);
However, 'len' was initialized earlier to skb_headlen(skb) (e.g. 42 bytes)
and is left unadjusted after padding. Consequently, dma_map_single() and
dma_unmap_len_set() map and track only 42 bytes.
Later, the hardware TX buffer descriptor is programmed with the padded length:
txbd->tx_bd_len_flags_type =
cpu_to_le32(((len + pad) << TX_BD_LEN_SHIFT) | flags |
TX_BD_FLAGS_PACKET_END);
The NIC DMA engine is thus instructed to read 52 bytes from a region where
only 42 bytes were DMA-mapped. If skb->data ends near the boundary of a 4KB
page (within 'pad' bytes of the next page), the hardware DMA read overruns
into the unmapped adjacent page, triggering an IOMMU fault.
This issue was exposed after commit 447cbe95ebb9 ("vlan: fix skb_under_panic
and races when toggling HW VLAN offload") because reserving extra VLAN
headroom rounded LL_RESERVED_SPACE from 48 up to 64 bytes, shifting skb->data
offsets and potentially causing small frames to land right against page
boundaries.
Fix this by using skb_put_padto(skb, BNXT_MIN_PKT_SIZE) in
bnxt_start_xmit(), before skb_shinfo(skb)->nr_frags is sampled,
because padding might linearize the skb.
This ensures skb->len and skb_headlen(skb) reflect the padded size so
that dma_map_single() maps the full buffer and the descriptor length is
consistent. This also removes the temporary 'pad' variable and masking logic.
The padding is done after the SW USO branch, otherwise
bnxt_sw_udp_gso_xmit() would account the padding as UDP payload
and send it in extra segments.
Note that SW USO segments are still not padded: with IPv4, a segment
carrying less than 10 bytes of UDP payload (small gso_size, or a short
last segment) is sent as a frame shorter than BNXT_MIN_PKT_SIZE.
This is a separate issue, left for a followup patch. |
| Out-of-bounds read in Windows Print Spooler Components allows an unauthorized attacker to disclose information over a network. |
| Out-of-bounds read in HID Parser Library allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Windows DNS allows an authorized attacker to deny service over a network. |
| Out-of-bounds read in Windows Overlay Filter allows an authorized attacker to elevate privileges locally. |
| Out-of-bounds read in Desktop Window Manager allows an authorized attacker to disclose information locally. |
| In the Linux kernel, the following vulnerability has been resolved:
regulator: tps6594-regulator: Fix n_linear_ranges for TPS65224 BUCK2-4
The TPS65224 BUCK2, BUCK3 and BUCK4 descriptors pass 4 as
n_linear_ranges, but tps65224_bucks_2_3_4_ranges[] only has two
entries, covering selectors 0x00-0x45.
The linear range helpers loop over n_linear_ranges entries, so any
lookup of a selector above 0x45 reads past the end of the array and
treats whatever follows it as two more ranges. This happens on the
normal registration path when the core checks the voltage constraints
against every selector. TPS652G1 uses the same descriptors and is
affected too.
Use ARRAY_SIZE() so the count always matches the table. |
| Out-of-bounds read in Microsoft Office PowerPoint allows an unauthorized attacker to disclose information over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-crypt: reject the lmk IV mode with AEAD ciphers
A "capi:" table line that pairs an AEAD cipher with the lmk IV mode,
for example "capi:gcm(aes)-lmk" with the integrity:28:aead option,
causes an oops when it is loaded. lmk sets tfms_count to 64, but
crypt_alloc_tfms_aead only allocates one transform, so crypt_setkey
reads past the end of the tfms_aead array and calls crypto_aead_setkey
on the values it finds there.
lmk exists for compatibility with Loop-AES, which uses CBC, so refuse
it with an AEAD cipher rather than allocate 64 AEAD transforms. The
check cannot go in crypt_iv_lmk_ctr with the other lmk checks, because
the IV constructor runs after crypt_set_key.
Note that this is not a security bug because the memory corruption can
only be triggered by root. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Validate BASE_ERROR_EVENT payload size
BASE_ERROR_EVENT carries a variable number of message reports,
with the count encoded in error_status. The notification parser used
that count without checking whether the received payload contained all
reported entries.
Reject truncated payloads before copying the report array. |
| When the HTTP stream wrapper follows a redirect and the response carries a Location header with an empty value, the redirect code reads one byte past the end of the heap buffer holding the location. The value of that out-of-bounds byte decides which redirect target is built, so a malicious server controls whether the client is sent to the host root or to the current directory. |
| The mysqlnd wire protocol parser reads fields out of server packets before checking that the packet still holds enough bytes for them. A malicious or compromised MySQL server can send a truncated packet and make the client read past the end of the packet buffer, which is undefined behaviour and can crash the process. |
| Antiword through 0.37 contains a stack out-of-bounds read vulnerability in vGet8PapInfo and vGet8ChrInfo in prop8.c because FKP run counts and grpprl offsets are not bounded. Attackers can supply a crafted .doc file with malicious FKP pages to read past the 512-byte stack buffer, crashing antiword or corrupting style parsing. |
| libmikmod through 3.3.15 contains a global out-of-bounds read vulnerability in the MultiTracker loader MTM_Load() because the module channel count is never clamped. Attackers can supply a crafted .mtm file with a channel count above 32 to read past the static pat array, corrupting track indices and crashing the loading application. |
| libmikmod through 3.3.15 contains a heap out-of-bounds read vulnerability in the IMF_Load() loader that allows attackers to read beyond allocated memory by supplying a crafted IMF module. Attackers can enable the linear-period header flag and map notes to out-of-range samples, causing noteindex indexing far past the heap allocation and crashing applications that load the file. |
| odhcpd is the DHCPv6, DHCPv4, and router-advertisement server used by OpenWrt. From version 17.01.0 to before version 25.12.3, odhcpd's DHCPv6 IA parser accepts an IA_NA or IA_PD option whose body is shorter than struct dhcpv6_ia_hdr, casts the option header to that full structure, and reads ia->iaid before proving that the IA body contains the IAID field. If an unauthenticated network-adjacent client places a zero-length or otherwise short IA option at the end of odhcpd's 8192-byte receive stack buffer, the IAID read crosses from data_buf into adjacent stack memory. The disclosed bytes are then reflected in the DHCPv6 reply IAID; prior ARM validation showed data_buf[8192:8196] disclosing the saved stack canary, and wider stack scans can leak ASLR-useful stack/process contents. This issue has been patched in version 25.12.3. |
| A flaw was found in libmodulemd. In the module stream v2 rpm-map emission path, an inner loop incorrectly uses the count of digest algorithms as its bound instead of the number of checksums in the current digest table. Crafted modulemd v2 metadata with multiple digest types can trigger an out-of-bounds read during YAML serialization, typically causing a crash and resulting in a denial of service. |
| The package github.com/gomarkdown/markdown is a Go library for parsing Markdown text and rendering as HTML. Prior to 0.0.0-20260724235538-61af6e1e6971, parser.IsSafeURL in parser/parser.go slices url[:nPath] before the len(url) >= nPath guard. A short destination causes a slice-bounds panic when the loop reaches a relative-path prefix for which len(url) < nPath and cap(url) < nPath. The one-byte destination / is an explicit non-panic counterexample because it matches the first valid path and returns before a longer prefix is sliced. Demonstrated panic cases include empty, ., and .. destinations under those conditions. The panic is reachable when markdown.ToHTML renders untrusted Markdown with html.Safelink enabled, including an empty link destination, and is also reachable by callers that pass a short attacker-controlled URL directly to the exported parser.IsSafeURL function. An uncaught panic can terminate the calling process and cause denial of service. This issue is fixed in 0.0.0-20260724235538-61af6e1e6971. |
